The ADM-64 rugged 3½ digit multimeter has a dual slope A-D converter. It uses C-MOS technology for auto-zeroing, polarity selection and over-range indication. It is ideal for use by electricians, electronic engineers, general industry and laboratories. Note 10A range is unfused/
Impact-resistant ABS plastic case with a protective rubber holster
40mm LCD display with large digits and function indicators
Manual ranging via 30-position positive click action rotary switch
Auto polarity indication on DC ranges
Fast blow fuse for overload protection
Auto power off
220 Vrms overload protection with fast blow fuse
Low battery indicator
Supplied with rubber holster, 2 test leads, K-Type thermocouple wire and battery
A calibration service can be purchased for this unit. Once the Service has been performed a certificate of calibration is produced and dispatched with your order. Calibration Services are performed on receipt of your order and as such will delay shipping. Details and options are outlined below.
Traceable Calibration (Multimeter)
Issued at 3 points - Contact Us for Details
Traceable certification is adequate for most applications and meets the calibration requirements of ISO 9001. All measurements contained in this type of certification are traceable back to National UKAS Standards.
Traceable Calibration (UKAS)
Issued at 3 points - Contact Us for Details
A UKAS calibration can also be considered traceable. The difference between the two is that UKAS calibrations are carried out under the remit of an ISO/IEC 17025 quality system by a laboratory that has been accredited by UKAS, to ensure the consistency and accuracy of results.
