The AEL-USB-TCLCD data logger measures and stores over 32,510 temperature readings for a K, J or T-Type thermocouple temperature probe. Simple download of the stored data directly to your PC or Laptops USB port. It has a high-contrast display with user selection of current temperature, maximum temperature or minimum temperature.
-200° to 1350°C x 1°
Accepts a K, J, or T-Type thermocouple temperature probe with the standard mini plug
USB interface for set up and data transfer to PC or Laptop
Set-up allows the user to select thermocouple type, logging rate, start time, alarm limits and logging mode
User selectable logging intervals – Min 1 sec, Max 12 hours
Green LED for logging confirmation
2 programmable alarm thresholds (high/low)
Red LED if alarm limits exceeded
Analysis software with graphical display of data – total readings, zoom facility to individual readings and visual indication of alarm levels
Supplied with software, K-Type thermocouple 1.3m cable with 100mm x 3mm immersion probe (0°C to 400°C) and battery
A calibration service can be purchased for this unit. Once the Service has been performed a certificate of calibration is produced and dispatched with your order. Calibration Services are performed on receipt of your order and as such will delay shipping. Details and options are outlined below.
Traceable certification is adequate for most applications and meets the calibration requirements of ISO 9001. All measurements contained in this type of certification are traceable back to National UKAS Standards.
Traceable Calibration (K-Type System - Unit + 1 Probe)
Issued at 4 points:
25, 50, 100, & 140°C
Additional points:
From -20 to 255°C
Traceable certification is adequate for most applications and meets the calibration requirements of ISO 9001. All measurements contained in this type of certification are traceable back to National UKAS Standards.
UKAS Calibration (K-Type System - Unit + 1 Probe)
Issued at 4 points:
25, 50, 100, & 140°C
Additional points:
-20 to 250°C
A UKAS calibration can also be considered traceable. The difference between the two is that UKAS calibrations are carried out under the remit of an ISO/IEC 17025 quality system by a laboratory that has been accredited by UKAS, to ensure the consistency and accuracy of results.
